|Liszt is a despooler to optimize the management of the plotters which use the HPGL language among which: Graphtec, Mutoh, Roland, Summa, ZŘnd, Jingwei, Aoke. A simple interface allows the user to control all settings and the execution sequence of a maximum of 8 tools.|
|Liszt takes the control of the printing process and makes AutoCAD«, ZWCAD« and
Mozart free to work during printing. You can continue working during the whole printing job.
Liszt is compatible with all Windows« and AutoCAD« versions.
Plotters can be connected using serial, parallel, USB or TCP/IP port.
Liszt is available in four versions.
Version 2 to plot directly from a computer to a plotter.
Version 3 to plot directly from a computer to many plotters.
Version 4 to plot directly from a computer to a plotter or postponed from many computers to a plotter.
Version 5 to plot directly or postponed from many computers to many plotters.
The table below resumes the functions of each version.
|Mozart can interface almost all plotters and cutting tables: pen plotters, vertical and flatbed cutting plotters, cutting tables based on knife, waterjet or laser technology. Mozart can be used with all plotters that accept HP-GL commands or have a driver for Windows« and all cutting tables that accept DXF files.|
Vertical cutting plotters
|Vertical cutting plotters are simple, fast and require a very few space to operate. They are suited for cutting the pattern on thin cardboard. The small size and the very low noise allow these plotters to be installed in any place. They are up to four time faster than a flatbed plotter. Some of them have up to 8 tools (pens and knives) to plot in several colors and cutting the pattern in a single printing operation. They can not cut thick cardboard. To prevent the detaching of the pieces during the cutting they perform a dashed cut. Pieces must be manually detached from carboard after the plotter has completed the job.|| |
Flatbed cutting plotters
|Flatbed cutting plotters are suggested to cut thick cardboard. The wide range of models offers a solution for any cutting requirement: from the more simple models without vacuum, up to the most complete machines with vacuum and multitools head (pen, knife, pouncher and mill). The models equipped with tangentially controlled and oscillating knife can cut reinforcements and some types of leathers and fabrics. The working surface starts from the 800x600 mm of the smaller models up to almost 3000x3000 mm.|
|Cutting system, specially those that can nest the pieces on
the material, are the ideal machines for cutting leather and others materials.
The three cutting technologies: oscillating knife, waterjet and laser, offer a wide range of solutions. Using the AAMA plug-in Mozart can interface all the most known cutting systems.
All product names, brand names or trademarks named here belong to their respective holders.